Register / log-in to add to your Hammerwall Collection.
Manual Location
The Search Results for the Search Section to the left will appear here.
Page: 1
Program © 2001 , 2002 , 2003 Sony Corporation 3 - 253 - 608 - 11 ( 2 ) Documentation © 2003 Sony Corporation System requirements • SonicStage , OpenMG and the OpenMG logo , MagicGate Memory Stick and the MagicGate Memory Stick The following hardware and software are required in order to use the Net MD Simple Burner logo , Memory Stick and the Memory Stick logo , Net MD and the Net MD logo are trademarks of Sony software for the Net MD . Corporation . • “ WALKMAN � is a registered trademark of Sony Corporation to represent Headphone Stereo products . is a trademark of Sony Corporation . Computer IBMPC / AT or Compatible • Microsoft , Windows , Windows NT and Windows Media are trademarks or registered trademarks of Net MD Microsoft Corporation in the United States and / or other countries . • CPU : Pentium II 400 MHz or higher ( Pentium III 450 MHz or higher • IBM and PC / AT are registered trademarks of International Business Machines Corporation . is recommended . ) • Macintosh is a trademark of Apple Computer , Inc . in the United States and / or other countries . • Hard disk drive space : 120 MB or more Simple Burner • MMX and Pentium are trademarks or registered trademarks of Intel Corporation . • RAM : 64 MB or higher ( 128 MB or higher is recommended . ) • All other trademarks and registered trademarks are trademarks or registered trademarks of their Others respective holders . Ver . 1.1 TM • CD - ROM drive ( capable of digital playback by WDM ) • and ® marks are omitted in this manual . • Sound Board • Copyright laws prohibit reproducing the software or the manual accompanying it in whole or in part , • USB port ( supports USB 2.0 Full Speed ( previously USB 1.1 ) ) for Net MD Walkman or renting the software without the permission of the copyright holder . Operating System Factory installed : • In no event will SONY be liable for any financial damage , or loss of profits , including claims made by third parties , arising out of the use of the software supplied with this recorder . Windows XP Home Edition / Windows XP Professional / Windows How to Install • In the event a problem occurs with this software as a result of defective manufacturing , SONY will Millennium Edition / Windows 2000 Professional / Windows 98 Second replace it . However , SONY bears no other responsibility . Edition • The software provided with this recorder cannot be used with equipment other than that which is so Display HighColor ( 16bit ) orgreater , 800 × 480 dots or more ( 800 × 600 dots or designated . more is recommended ) • Please note that , due to continued efforts to improve quality , the software specifications may be changed without notice . Others Internetaccess : forsoftware upgrades and CDDB2 use Notes • The recorded music is limited to private use only . Use of the music beyond this limit requires permission of the copyright holders . This software is not supported by the following environments : • Sony is not responsible for music files that are not saved on your computer due to unsuccessful • Macintosh recording from CD or music downloading . • Windows XP versions other than Home Edition or Professional • Windows 2000 versions other than Professional For details on the operation of a Net MD , refer to the Net MD • Windows 98 versions other than Second Edition Operating Instructions . • Windows NT • Windows 95 • Personally constructed PCs or operationg systems • An environment that is an upgrade of the original manufacturer - installed operating system Overview • Multi - boot environment This manual explains Net MD Simple Burner software installation for use with a Net MD . This • Multi - monitor environment software makes it easy to record tracks from an audio CD in the CD - ROM drive of a PC to an MD in the Net MD . Net MD Simple Burner also allows you to do MD editing operations from Notes your computer , such as labeling or erasing tracks , etc . • We do not ensure trouble - free operation for all computers that satisfy the system requirements . For details on Net MD Simple Burner operations , refer to the Operating Instructions supplied • We do not ensure trouble - free operation of the system suspend , sleep , or hibernation function on all with the Net MD Simple Burner software . computers . For details on the use of the Net MD , refer to the Operating Instructions supplied with your Net MD . Notes • The illustrations in this manual may differ from the actual software . • Explanations in this manual assume that you are familiar with basic operations of Windows . For how to Sony Corporation © 2003 Printed in Malaysia use your computer and operating system , please refer to the respective manuals .
Page: 2
4 Follow the displayed instructions and restart the computer after the installation is completed . Installing Net MD Simple Burner Notes on system suspend / hibernation mode • If the computer changes to system suspend / hibernation mode during the recording of a CD 5 Connect your Net MD to your computer . or the checking in / out of a data file , the audio data may be lost or the computer may not Before the installation 6 Start Net MD Simple Burner . wake up properly . The computer suspend / hibernation function should therefore be turned Refer to the Operating Instructions for operations . off . • Do not connect the dedicated USB cable before the installation . • If you change the media while the computer is in system suspend / hibernation mode , audio The software may not correctly load or operate if the dedicated USB cable is connected To check the information ( such as its version ) of the Net MD Simple data may be lost after the computer wakes up . to your computer during the installation . Burner software • If the computer changes to system suspend / hibernation mode , the computer may not • Close all other Windows applications before starting the installation . recognize the Net MD when it wakes up . If this happens , disconnect the dedicated USB Click [ Net MD Simple Burner ] icon , and then click [ About Net MD Simple Burner ] . Make sure to close any virus - check software , as such software usually demand large cable and reconnect it again . amounts of system resources . • Notes on using Net MD Simple Burner with Windows XP / Windows Uninstalling Net MD Simple Burner 2000 If your computer does not recognize the Net MD If your computer is Windows XP Home Edition , Windows XP Professional , or Follow the instructions below to uninstall the Net MD Simple Burner software . Windows 2000 Professional , please be aware of the following before installing Net MD • Is the Net MD connected correctly to your computer ? Simple Burner . For Windows XP / Windows 2000 users — If the Net MD is not firmly connected to the computer , the Net MD will not be recognized by — With Windows XP Home Edition or Windows XP Professional , you must log on with a your computer . user name with “ Computer Administrator � as an attribute to install Net MD Simple Log on as an Administrator / Computer Administrator , and then follow the instructions below . — Reconnect the dedicated USB cable . If the computer still does not recognize the Net MD , Burner . To check whether a user name has the attribute of “ Computer Administrator � Refer to the operating instructions of your computer for details on logging on an disconnect the Net MD , restart the computer , and connect the dedicated USB cable again . or not , go to [ Control Panel ] - [ User Account ] . administrator . — With Windows 2000 Professional , you must log on as “ Administrator � to install Net MD • Is an MD inserted in the Net MD ? 1 On Windows XP , click [ Start ] – [ Control Panel ] . Simple Burner . Check if an MD is inserted in the Net MD . On Windows 2000 , click [ Start ] – [ Settings ] – [ Control Panel ] . • If an earlier version of OpenMG Jukebox , SonicStage , or The Control Panel window appears . • If your computer does not recognize your Net MD even when the Net SonicStage Premium is installed Depending on the version of your software , the existing software may be overwritten MD is connected and a disc is inserted , the Net MD driver may not be 2 Double - click [ Add / Remove Programs ] . by the new version or it may co - exist with SonicStage Ver . 1.5 . As the installation correctly installed . The “ Add / Remove Programs � dialog box appears . process will depend on the version , refer to SonicStage Ver . 1.5 “ Software Operation � Go to the [ USB Controller ] in Windows Device Manager window to verify that your Net 3 Click [ Change or Remove Programs ] . section in the supplied Operating Instructions . MD is correctly recognized . A [ ! ] mark in the Device Manager window indicates that your Net MD is not correctly 4 On Windows XP , click [ Net MD Simple Burner ] in the “ Currently Installed recognized . Reinstall the Net MD driver . Installation Programs � list , and then click [ Change and Remove ] . On Windows 2000 , click [ Net MD Simple Burner ] in the “ Currently Installed 1 ) Install the Net MD Simple Burner software to the hard disk drive of your computer . 1 Click [ Start ] - [ Settings ] - [ Control Panel ] . Programs � list , and then click [ Change / Remove ] . 2 ) 1 Turn on your computer and start up Windows in advance . 2 Double click [ System ] in the control panel . Close all applications before you start installing . 3 ) 3 Click the [ Hardware ] tab , and then click [ Device Manager ] . For Windows Me / Windows 98 Second Edition users • When you use Windows XP / Windows 2000 : you must log on as an Administrator . The Device Manager window appears . • When an earlier version of OpenMG Jukebox , SonicStage , or SonicStage Premium is 1 ) 1 Click [ Start ] – [ Settings ] – [ Control Panel ] to display the Control Panel . In Windows XP , select [ Start ] - [ Control Panel ] . installed : if an icon of the existing software is displayed on the Task tray , remove it 2 ) In Windows XP , double click [ System ] if the control panel is in the “ classic � format , or click from the Task tray . 2 Double - click [ Add / Remove Programs ] . [ Performance and Maintenance ] and then [ System ] if the control panel is in the “ category � format . 2 Insert the installation CD - ROM of the SonicStage into the CD - ROM drive 3 ) The Add / Remove Programs Property window appears . Depending on your system , the [ Hardware ] tab may not be provided . In this case , click the [ Device Manager ] tab to display the Device Manager window . of your computer . 3 Click [ Net MD Simple Burner ] in the list of programs for automatic removal , The setup program starts up automatically . The installation window appears . and then click [ Add / Remove ] . 3 Click to select [ SonicStage 1.5 • Simple Burner ] .